Home / Guides / Engine failure after takeoff
Fenix A320 · Abnormal procedures

Engine failure after takeoff in the Fenix A320: what to do, in order.

It's the failure everyone practises and most people rush. Here's the sequence from the moment the engine quits to lining up for the return, including the secondary flight plan trick that makes the return easy.

Flight Sim Academy · 19 October 2026 · Simulation use only

What you'll see

ENG 1 (or 2) FAIL on the upper ECAM, the aircraft yawing towards the dead engine, and its N2, EGT and fuel flow dropping fast. If there's a bang, heavy vibration or no N2 at all, treat it as damage. A red ENG FIRE warning is different: see engine fire on takeoff.

1. Below 400 ft: just fly

  • Keep it straight with rudder against the yaw.
  • Follow the SRS pitch bar. It flies V2, or the speed you had if you were already faster.
  • Leave the thrust levers in TOGA or FLX until the thrust reduction altitude.
  • No ECAM actions until you're above 400 ft with the flight path under control.

2. Above 400 ft: the ECAM actions

  1. ENG MODE SEL → IGN. It backs up the FADEC's automatic relight.
  2. Affected THR LEVER → IDLE.
  3. No relight after 30 seconds: affected ENG MASTER → OFF. Confirm it's the right engine first.
  4. If there's damage: affected ENG FIRE P/B → PUSH, then AGENT 1 → DISCH after 10 seconds.

The classic mistake is shutting down the good engine. Say out loud which engine has failed and touch the lever or switch before you move it.

3. At engine-out acceleration altitude

  1. Push the V/S knob to level off and let the speed build.
  2. Retract the flaps on schedule as you pass F, then S speed.
  3. At green dot, pull ALT for OP CLB. The climb continues at green dot speed.
  4. Live engine THR LEVER → MCT when LVR MCT flashes on the FMA.

4. Declare and get vectors

RADIOMAYDAY, MAYDAY, MAYDAY, Manchester Radar, Speedbird 21A, engine failure left engine, intend to return to Manchester, passing 3,000 feet climbing 5,000 feet, heading 230.

ATC will usually give you a level to maintain and ask for persons on board and endurance. Answer when you're able. Flying comes first.

5. The return: use the secondary flight plan

This is where most sim pilots lose time, typing a new destination and approach while flying on one engine. The fix is to build the return before you push back, in the SEC F-PLN.

  1. Before departure: SEC F-PLN → COPY ACTIVE, then set your departure airport as NEW DEST from the first SID waypoint, and add the approach. (Step by step in our MCDU tutorial.)
  2. After the failure: if NAV is engaged and you're on a different leg, select HDG on the FCU first.
  3. SEC F-PLN → ACTIVATE SEC (4L). The return is now your active plan.
  4. Use DIR TO for the waypoint ATC gives you, or stay on vectors. Check PERF APPR, RAD NAV and the landing data.

Don't press EO CLR* on the PERF page. It tells the FMS both engines are working again.

6. The one-engine approach

  • Flaps full only on the final descent. If you might have to level off on final, land in CONF 3.
  • Landing in CONF 3? Set LDG FLAP 3 on the GPWS panel so you don't get a false warning.
  • Straight after takeoff you'll probably be overweight. Check the landing performance before you commit.

Practise it

Set an engine failure from the Fenix EFB Failures app or the MCDU, armed for just after takeoff. In Flight Sim Academy, the ECAM lookup and the Engine Failure and Engine Out Return cards in Abnormal Procedures walk you through all of this, with the radio calls, while you fly.

FAQ

Engine failure questions

When do I start ECAM actions after an engine failure on takeoff?

Not below 400 ft above the ground. Fly the aircraft first: keep it straight with rudder, follow the SRS pitch bar, and leave the thrust levers where they are.

Should I press EO CLR on the PERF page?

No. EO CLR tells the flight management system that both engines are working again, which removes the engine-out predictions you need.

Can I use flaps full on a one-engine approach?

Only once you're on the final descent. If you might need to level off on final or go around, land in CONF 3 and set LDG FLAP 3 on the GPWS panel.

Fly the whole flight in the right order.

Start free with Pre-Flight and Cockpit Preparation. Unlock all 21 phases, In-Flight Assistance and 13 abnormal procedures for £9.99, once.